Safety Data Sheet

SDS - FloraFert Enhance II - 250930

English 164 KB PDF Valid until 2030-09-30

Applies to Enhance II Granular Fertiliser

Document contents

Text extracted from the source document for accessibility and reference. Always consult the original safety data sheet above for the authoritative version.

Safety Data Sheet

Prepared in accordance with the WHS Regulations 2011 and the Code of Practice – Preparation of SDS for Hazardous Chemicals (Safe Work Australia). Conforms to the Globally Harmonised System (GHS, 7th Edition).

1. Identification of the Product and Supplier

Product name: FloraFert Enhance II

Recommended use: Fertiliser

Supplier: Fernland Agencies Pty Ltd

Address: 31–35 Paulger Flat Road, Yandina, QLD 4561, Australia

Emergency contact (24 hr):

  • Fernland Agencies:
  • Poisons Information Centre (Australia): 13 11 26

2. Hazard Identification

Classification under GHS (Australia): This product is not classified as hazardous according to the Globally Harmonised System (7th edition) as adopted under the WHS Regulations.

Label elements (GHS):

  • Signal word: None
  • Hazard pictograms: None
  • Hazard statements: Not classified as hazardous.
  • Precautionary statements: General safe handling practices apply.

Other hazards:

  • Harmful if swallowed in large amounts.
  • Prolonged skin contact may cause mild irritation.
  • May cause long-term adverse effects in the aquatic environment.

3. Composition / Information on Ingredients

Component CAS No. Proportion Classification (GHS Australia)
Ammonium sulfate 7783-20-2 10–20% Not classified
Potassium sulfate 7778-80-5 20–30% Not classified
Magnesium sulfate heptahydrate 10034-99-8 10–20% Not classified
Methylene urea (MDU) 13547-17-6 20–40% Not classified
Disodium tetraborate 12179-04-3 <0.1% Repr. 1B (H360FD)

4. First Aid Measures

General advice: Seek medical attention if symptoms persist. Show this SDS to the doctor.

  • Inhalation: Move to fresh air. If breathing difficulty occurs, seek medical advice.
  • Skin contact: Wash with soap and water. If irritation persists, get medical attention.
  • Eye contact: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do. Continue rinsing. If irritation persists, seek medical advice.
  • Ingestion: Rinse mouth with water. Give water to drink. Do not induce vomiting. If unwell, contact the Poisons Information Centre (13 11 26) or a doctor.

Symptoms: Nausea, vomiting, diarrhoea if swallowed; mild skin or eye irritation with prolonged exposure.

5. Firefighting Measures

Suitable extinguishing media: Water spray, foam, dry chemical. Unsuitable extinguishing media: Sand, CO₂ alone may be less effective. Hazards from combustion products: Heating can release sulphur oxides (SO₂, SO₃), nitrogen oxides (NOx), ammonia, and phosphorus oxides. Avoid inhaling decomposition gases. Protective equipment for firefighters: Wear self-contained breathing apparatus (AS/NZS 1716) and protective clothing.

6. Accidental Release Measures

Personal precautions: Avoid generating dust. If dust is present, wear eye protection and a dust mask/respirator. Environmental precautions: Prevent entry into drains, waterways, or soil. Product may contribute to nutrient loading in water systems (eutrophication). Spill clean-up: Collect mechanically. Avoid creating dust. Dispose of according to Section 13.

7. Handling and Storage

Precautions for safe handling:

  • Avoid breathing dust.
  • Wash hands after use.
  • Use in accordance with fertiliser application guidelines.

Conditions for safe storage:

  • Store in original, sealed container.
  • Keep dry and away from sources of heat or ignition.
  • Avoid contact with strong acids or alkalis.
  • Storage class: Store away from incompatible chemicals.

8. Exposure Controls / Personal Protection

National exposure standards (Safe Work Australia):

  • Dust (inspirable): TWA 10 mg/m³
  • Dust (respirable): TWA 3 mg/m³

Engineering controls: Use in well-ventilated areas. Avoid dust accumulation.

Personal protective equipment (PPE):

  • Respiratory: P1 or P2 dust mask if dust levels exceed exposure limits.
  • Hands: Nitrile gloves if prolonged contact is expected.
  • Eyes: Safety glasses with side shields.
  • Skin: Long sleeves and trousers recommended when handling bulk product.

9. Physical and Chemical Properties

Appearance: Granules, grey/yellow Odour: Slight pH (1% solution): 6.0–7.5 Solubility: Contains water-soluble components Apparent density: 800–1200 g/L Relative density: Not relevant Melting point/decomposition: Decomposes at ~260 °C Flammability: Non-flammable, but may release gases if heated Oxidising properties: Not oxidising

10. Stability and Reactivity

Reactivity: Heating may release sulphur oxides, nitrogen oxides, ammonia, and phosphorus oxides. Chemical stability: Stable under normal conditions of storage and use. Conditions to avoid: High humidity, excessive heat. Incompatible materials: Strong acids and alkalis. Hazardous decomposition products: Ammonia, sulphur oxides, nitrogen oxides, phosphorus oxides.

11. Toxicological Information

Acute oral toxicity: LD₅₀ (oral, rat) > 2000 mg/kg (low toxicity). Skin/eye irritation: Prolonged exposure may cause mild irritation. Sensitisation: Not expected to cause sensitisation. Carcinogenicity: No data available; not classified. Reproductive toxicity: Disodium tetraborate present at <0.1% — classified as Repr. 1B (may damage fertility or the unborn child). Other information: Not expected to cause significant adverse health effects under normal use.

12. Ecological Information

Aquatic toxicity (selected components):

  • Ammonium sulphate: LC₅₀ (fish, 48h): 365 mg/L
  • Potassium sulphate: LC₅₀ (fish, 96h): 1530 mg/L
  • Magnesium sulphate: LC₅₀ (fish, 96h): 2820 mg/L
  • Disodium tetraborate: LC₅₀ (fish, 96h): 71 mg/L

Persistence/degradability: Inorganic salts are water-soluble. Bioaccumulation: Not expected. Mobility in soil: May leach into groundwater. Other adverse effects: May contribute to eutrophication of water systems.

13. Disposal Considerations

Product: Dispose of in accordance with local, state, and federal regulations. Packaging: Can be recycled or disposed of as solid waste if cleaned. Do not dispose into waterways or drains.

14. Transport Information

Classified as non-dangerous goods under the Australian Dangerous Goods (ADG) Code. UN Number: Not applicable Proper shipping name: Fertiliser mixture (non-hazardous) Hazard class: Not applicable Packing group: Not applicable Environmental hazards: Not classified as marine pollutant

15. Regulatory Information

Classified according to the WHS Regulations 2011. Not classified as hazardous under GHS (7th Edition) except for trace disodium tetraborate (<0.1%). Not scheduled under the Standard for the Uniform Scheduling of Medicines and Poisons (SUSMP).

16. Other Information

Date of issue: 30 September 2025 Supersedes: Version dated 14 April 2021 References:

  • Safe Work Australia – Hazardous Chemical Information System (HCIS)
  • ADG Code, Edition 7.8
  • GHS (7th Edition), UN Recommendations

Disclaimer: The information provided is believed to be accurate and reliable at the date of issue. No warranty, express or implied, is made as to the accuracy or completeness of this data. The responsibility for safe use, handling, storage, and disposal rests with the user.