SDS - Searles Trace Element Mix - 250301
Applies to Trace Element Mix
Document contents
Text extracted from the source document for accessibility and reference. Always consult the original safety data sheet above for the authoritative version.
Product Name: Searles Trace Element Mix Page: 1 of 5 This revision issued: March, 2025
Section 1 - Identification of the Material and Supplier
J.C. & A.T. Searle Pty Ltd Phone: (BH) 4914 D’aguilar Highway (PO Box 183) Fax: Kilcoy, Qld 4515 Chemical nature: Blend of ingredients. Trade Name: Searles Trace Element Mix Product Code: TE700 Product Use: Fertiliser for gardens and other horticultural purposes. Creation Date: June, 2007 This version issued: March, 2025 and is valid for 5 years from this date. Poisons Information Centre: Phone 13 1126 from anywhere in Australia
Section 2 - Hazards Identification
Statement of Hazardous Nature SUSMP Classification: None allocated. ADG Classification: None allocated. Not a Dangerous Good under the ADG Code. UN Number: None allocated GHS Signal word: NONE. Not hazardous. PREVENTION P102: Keep out of reach of children. P262: Do not get in eyes, on skin, or on clothing. P281: Use personal protective equipment as required. RESPONSE P337: If eye irritation persists: seek medical attention. P352: Wash with plenty of soap and water. P301+P330+P331: IF SWALLOWED: Rinse mouth. Do NOT induce vomiting. P370+P378: Not combustible. Use extinguishing media suited to burning materials. STORAGE P402+P404: Store in a dry place. Store in a closed container. DISPOSAL P501: If product can not be recycled, consider controlled incineration, or contact a specialist waste disposal company (see Section 13 of this SDS).
Emergency Overview
Physical Description & Colour: Fine granules of varying colour and size. Odour: No odour. Major Health Hazards: no significant risk factors have been found for this product.
Section 3 - Composition/information on Ingredients
| Ingredients | CAS No | Conc,% | TWA (mg/m³) | STEL (mg/m³) |
|---|---|---|---|---|
| Ferrous sulfate heptahydrate | 7782-63-0 | <20 | 1 | not set |
| Copper sulfate pentahydrate | 7758-99-8 | <5 | not set | not set |
| Zinc sulfate heptahydrate | 7733-02-0 | <5 | not set | not set |
| Other non hazardous ingredients | secret | to 100 | not set | not set |
This is a commercial product whose exact ratio of components may vary slightly. Minor quantities of other non hazardous ingredients are also possible. The SWA TWA exposure value is the average airborne concentration of a particular substance when calculated over a normal 8 hour working day for a 5 day working week. The STEL (Short Term Exposure Limit) is an exposure value that may be equalled (but should not be exceeded) for no longer than 15 minutes and should not be repeated more than 4 times per day. There should be at least 60 minutes between successive exposures at the STEL. The term "peak "is used when the TWA limit, because of the rapid action of the substance, should never be exceeded, even briefly.
SAFETY DATA SHEET Issued by: J.C. & A.T. Searle Pty Ltd Phone: Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand)
Product Name: Searles Trace Element Mix Page: 2 of 5 This revision issued: March, 2025
Section 4 - First Aid Measures
General Information: You should call The Poisons Information Centre if you feel that you may have been poisoned, burned or irritated by this product. The number is 13 1126 from anywhere in Australia (0800 764 766 in New Zealand) and is available at all times. Have this SDS with you when you call. Inhalation: First aid is not generally required. If in doubt, contact a Poisons Information Centre or a doctor. Skin Contact: Gently brush away excess solids. Irritation is unlikely. However, if irritation does occur, flush with lukewarm, gently flowing water for 5 minutes or until chemical is removed. Eye Contact: Quickly and gently brush particles from eyes. Immediately flush the contaminated eye(s) with lukewarm, gently flowing water for 5 minutes or until the product is removed, while holding the eyelid(s) open. Obtain medical advice immediately if irritation occurs. Take special care if exposed person is wearing contact lenses. Ingestion: If product is swallowed or gets in mouth, do NOT induce vomiting; wash mouth with water and give some water to drink. If symptoms develop, or if in doubt contact a Poisons Information Centre or a doctor.
Section 5 - Fire Fighting Measures
Fire and Explosion Hazards: There is no risk of an explosion from this product under normal circumstances if it is involved in a fire. No fire decomposition products are expected from this products at temperatures normally achieved in a fire. Fire decomposition products from this product may be toxic if inhaled. Take appropriate protective measures. Extinguishing Media: Not Combustible. Use extinguishing media suited to burning materials. Fire Fighting: If a significant quantity of this product is involved in a fire, call the fire brigade. Flammability Class: Does not burn.
Section 6 - Accidental Release Measures
Accidental release: Minor spills do not normally need any special cleanup measures. In the event of a major spill, prevent spillage from entering drains or water courses. As a minimum, wear overalls, goggles and gloves. Suitable materials for protective clothing include cotton, rubber, PVC. Eye/face protective equipment should comprise as a minimum, protective glasses and, preferably, goggles. If there is a significant chance that dusts are likely to build up in cleanup area, we recommend that you use a suitable Dust Mask. Use a P1 mask, designed for use against mechanically generated particles eg silica & asbestos. Stop leak if safe to do so, and contain spill. Sweep up and shovel or collect recoverable product into labelled containers for recycling or salvage, and dispose of promptly. Consider vacuuming if appropriate. Recycle containers wherever possible after careful cleaning. After spills, wash area preventing runoff from entering drains. If a significant quantity of material enters drains, advise emergency services. This material may be suitable for approved landfill. Ensure legality of disposal by consulting regulations prior to disposal. Thoroughly launder protective clothing before storage or re-use. Advise laundry of nature of contamination when sending contaminated clothing to laundry.
Section 7 - Handling and Storage
Handling: Keep exposure to this product to a minimum, and minimise the quantities kept in work areas. Check Section 8 of this SDS for details of personal protective measures, and make sure that those measures are followed. The measures detailed below under "Storage" should be followed during handling in order to minimise risks to persons using the product in the workplace. Also, avoid contact or contamination of product with incompatible materials listed in Section 10. Storage: Make sure that the product does not come into contact with substances listed under "Incompatibilities" in Section 10. Check packaging - there may be further storage instructions on the label.
Section 8 - Exposure Controls and Personal Protection
The following Australian Standards will provide general advice regarding safety clothing and equipment: Respiratory equipment: AS/NZS 1715, Protective Gloves: AS 2161, Occupational Protective Clothing: AS/NZS 4501 set 2008, Industrial Eye Protection: AS1336 and AS/NZS 1337, Occupational Protective Footwear: AS/NZS2210.
| SWA Exposure Limits | TWA (mg/m³) | STEL (mg/m³) |
|---|---|---|
| Ferrous sulfate | 1 | not set |
No special equipment is usually needed when occasionally handling small quantities. The following instructions are for bulk handling or where regular exposure in an occupational setting occurs without proper containment systems.
SAFETY DATA SHEET Issued by: J.C. & A.T. Searle Pty Ltd Phone: Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand)
Product Name: Searles Trace Element Mix Page: 3 of 5 This revision issued: March, 2025
Ventilation: This product should only be used where there is ventilation that is adequate to keep exposure below the TWA levels. If necessary, use a fan. Eye Protection: Eye protection such as protective glasses or goggles is recommended when this product is being used. Skin Protection: The information at hand indicates that this product is not harmful and that normally no special skin protection is necessary. However, we suggest that you routinely avoid contact with all chemical products and that you wear suitable gloves (preferably elbow-length) when skin contact is likely. Protective Material Types: We suggest that protective clothing be made from the following materials: cotton, rubber, PVC. Respirator: If there is a significant chance that dusts are likely to build up in the area where this product is being used, we recommend that you use a suitable Dust Mask.
Section 9 - Physical and Chemical Properties:
Physical Description & colour: Fine granules of varying colour and size. Odour: No odour. Boiling Point: Not available. Flash point: Does not burn. Upper Flammability Limit: Does not burn. Lower Flammability Limit: Does not burn. Autoignition temperature: Not applicable - does not burn. Freezing/Melting Point: No specific data. Solid at normal temperatures. Volatiles: No specific data. Expected to be low at 100°C. Vapour Pressure: Negligible at normal ambient temperatures. Vapour Density: No data. Specific Gravity: No data. Water Solubility: Soluble. pH: No data. Volatility: Negligible at normal ambient temperatures. Odour Threshold: No data. Evaporation Rate: No data. Coeff Oil/water Distribution: No data Particle Characteristics: Fine granules.
Section 10 – Stability and Reactivity
Reactivity: This product is unlikely to react or decompose under normal storage conditions. However, if you have any doubts, contact the supplier for advice on shelf life properties. Conditions to Avoid: None known. Incompatibilities: No particular Incompatibilities. Fire Decomposition: No significant quantities of decomposition products are expected at temperatures normally achieved in a fire. Water. Polymerisation: This product will not undergo polymerisation reactions.
Section 11 - Toxicological Information
Local Effects: Target Organs: There is no data to hand indicating any particular target organs.
Classification of Hazardous Ingredients
Ingredient: Ferrous sulfate heptahydrate Health Hazard Statement Codes: H302, H319, H315
- Acute toxicity – category 4
- Eye irritation – category 2
- Skin irritation – category 2
SAFETY DATA SHEET Issued by: J.C. & A.T. Searle Pty Ltd Phone: Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand)
Product Name: Searles Trace Element Mix Page: 4 of 5 This revision issued: March, 2025
Ingredient: Copper sulfate pentahydrate Health Hazard Statement Codes: H302, H318, H410
- Acute toxicity (ingestion) – category 4 (ATE = 481 mg/kg bw)
- Eye damage – category 1
- Hazardous to the aquatic environment (acute) – category 1 (M = 10)
- Hazardous to the aquatic environment (chronic) – category 1 (M = 1)
Potential Health Effects
Inhalation: Short Term Exposure: Long term inhalation of high amounts of any nuisance dust may overload lung clearance mechanism. Available data indicates that this product is not harmful. However product may be mildly irritating, although unlikely to cause anything more than mild transient discomfort. Long Term Exposure: No data for health effects associated with long term inhalation. Skin Contact: Short Term Exposure: Available data indicates that this product is not harmful. It should present no hazards in normal use. In addition product is unlikely to cause any discomfort in normal use. Long Term Exposure: No data for health effects associated with long term skin exposure. Eye Contact: Short Term Exposure: This product is believed to be mildly irritating, to eyes, but is unlikely to cause anything more than mild transient discomfort. Long Term Exposure: No data for health effects associated with long term eye exposure. Ingestion: Short Term Exposure: Significant oral exposure is considered to be unlikely. However, this product is believed to be mildly irritating to mucous membranes but is unlikely to cause anything more than mild transient discomfort. Long Term Exposure: No data for health effects associated with long term ingestion. Carcinogen Status: SWA: No significant ingredient is classified as carcinogenic by SWA. NTP: No significant ingredient is classified as carcinogenic by NTP. IARC: No significant ingredient is classified as carcinogenic by IARC.
Section 12 - Ecological Information
This product is unlikely to adversely effect the environment. Salts, acids and bases are typically diluted and neutralised when released to the environment in small quantities.
Section 13 - Disposal Considerations
Disposal: Dispose of small quantities and empty containers by wrapping with paper and putting in garbage. For larger quantities, if recycling or reclaiming is not possible, use a commercial waste disposal service.
Section 14 - Transport Information
UN Number: This product is not classified as a Dangerous Good by ADG, IATA or IMDG/IMSBC criteria. No special transport conditions are necessary unless required by other regulations.
Section 15 - Regulatory Information
AIIC: All of the significant ingredients in this formulation are compliant with AICIS regulations. The following ingredients: Ferrous sulfate, Copper sulfate, Zinc sulfate, are mentioned in the SUSMP.
Section 16 - Other Information
This SDS contains only safety-related information. For other data see product literature. Acronyms: ADG Code: Australian Code for the Transport of Dangerous Goods by Road and Rail, 7th Edition AIIC: Australian Inventory of Industrial Chemicals SWA: Safe Work Australia, formerly ASCC and NOHSC CAS Number: Chemical Abstracts Service Registry Number
SAFETY DATA SHEET Issued by: J.C. & A.T. Searle Pty Ltd Phone: Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand)
Product Name: Searles Trace Element Mix Page: 5 of 5 This revision issued: March, 2025
IARC: International Agency for Research on Cancer NTP: National Toxicology Program (USA) SUSMP: Standard for the Uniform Scheduling of Medicines & Poisons UN Number: United Nations Number
THIS SDS SUMMARISES OUR BEST KNOWLEDGE OF THE HEALTH AND SAFETY HAZARD INFORMATION OF THE PRODUCT AND HOW TO SAFELY HANDLE AND USE THE PRODUCT IN THE WORKPLACE. EACH USER MUST REVIEW THIS SDS IN THE CONTEXT OF HOW THE PRODUCT WILL BE HANDLED AND USED IN THE WORKPLACE. IF CLARIFICATION OR FURTHER INFORMATION IS NEEDED TO ENSURE THAT AN APPROPRIATE RISK ASSESSMENT CAN BE MADE, THE USER SHOULD CONTACT THIS COMPANY SO WE CAN ATTEMPT TO OBTAIN ADDITIONAL INFORMATION FROM OUR SUPPLIERS OUR RESPONSIBILITY FOR PRODUCTS SOLD IS SUBJECT TO OUR STANDARD TERMS AND CONDITIONS, A COPY OF WHICH IS SENT TO OUR CUSTOMERS AND IS ALSO AVAILABLE ON REQUEST.
Please read all labels carefully before using product. This SDS is prepared in accord with the SWA document “Preparation of Safety Data Sheets for Hazardous Chemicals - Code of Practice” (July 2020) and GHS Revision 7 Copyright © Kilford & Kilford Pty Ltd, March, 2025.
SAFETY DATA SHEET Issued by: J.C. & A.T. Searle Pty Ltd Phone: Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand)