---
title: Label - PCT Pounce 500 - 220914
canonical: https://fernland.com.au/documents/813/
dateModified: 2026-07-12 07:55:10
summary: Product Label
type: label
---

# Label - PCT Pounce 500 - 220914

> Product Label

POISON
KEEP OUT OF REACH OF CHILDREN
READ SAFETY DIRECTIONS BEFORE OPENING OR USING

POUNCE 500
TIMBER & RESIDUAL
INSECTICIDE
Active Constituent:
500g/L PERMETHRIN 75:25
SOLVENT 385g/L HYDROCARBON LIQUID
GROUP 3A INSECTICIDE

For control of a wide range of insect pests in various
situations as per the Directions of Use table

IMPORTANT
DIRECTIONS FOR USE BOOKLET
This booklet must be read for detailed directions for use.
To be read in conjunction with label affixed to container

PCT
PEST CONTROL TECHNOLOGIES
INTERNATIONAL PTY LTD
(PCT Holdings Pty Ltd)
252 Bradman Street, Acacia Ridge QLD 4110 •
CUSTOMER SERVICE FREECALL
EMERGENCY RESPONSE (ALL HOURS) FREECALL
NRA Approval No: 49211/0503 'Pounce 500 is a registered trademark of PCT International'

---

**DIRECTIONS FOR USE**

| SITUATION | INSECTS | RATE | CRITICAL COMMENTS |
| :--- | :--- | :--- | :--- |
| Felled logs, poles, posts and sawn timber. | Auger beetle (Bostrychidae), Powder post beetles (Lyctidae), Pinhole borers (Scolytidae), Furniture Beetles | 20mL in 10L of water | 1. Log coils and poles (especially when debarked) and sawn timber: use a knapsack or power sprayer at 700mL/m². 2. Keep timber moist at location of treatment. |
| Remedial treatment of timber in buildings | Auger beetle (Bostrychidae), Powder post beetles (Lyctidae), Pinhole borers (Scolytidae), Furniture Beetles | 40mL in 10L of non-staining oil or kerosene | Applicable only to surfaces that will absorb the solution. Active ingredient, applied to polished surfaces need to be sanded down to ensure penetration of the solution. Apply at 1L/5m². A surface layer is at the point of "run-off". Drill damaged areas and inject solution until timber is unable to absorb more liquid. Signs of infestation are indicated by expulsion of frass for maximum effect. A single application may be sufficient. Continued expulsion of frass may be due to larvae and embryos. Do not use diesel or in under dying areas as odours and staining may occur. |
| Sawn or round timbers for treatment by vacuum impregnation | Auger beetle (Bostrychidae), Powder post beetles (Lyctidae), Pinhole borers (Scolytidae), Furniture Beetles | 12mL per 100kg of timber (in water) | 1. Calculate uptake of suitable diluent etc. (Refer application) 2. 12mL Pounce 500 in white spirit as calculated above. 3. Apply to timber through vacuum treatment equipment in accord with manufacturer's direction. 4. Ensure all 12mL is used. Split uptake equals that calculated in (1). |
| Groundline treatment of power poles | Subterranean termites (including Coptotermes spp. et al), Mastotermes darwiniensis, (North of Tropic of Capricorn) | 40mL in 10L of creosote or 100mL in 10L kerosene | Calculate required dose and mix. Apply at 30-40mL. Apply 5L of mixture to the pole at ground level and puddle the backfill with remaining 5L. |
| Softwood particle board manufacture | Subterranean termites (including Coptotermes spp. et al), Mastotermes darwiniensis, (North of Tropic of Capricorn) | 0.56mL/kg dry fibre (gives 0.3g permethrin per 0.5kg) | Dilute as required for metered addition into the glue. Add sufficient Pounce 500 to achieve weight of the fibre component only of the boards. |
| Processing and softwood plywood | Termites (including Coptotermes spp. et al), Mastotermes darwiniensis, (North of Tropic of Capricorn) | 360mL/m³ dry veneer (gives 180g permethrin per 1m³) | 1. Calculate the uptake of solution by veneers traversing a shallow dip bath. 2. Dilute as required to ensure the mean target application of Pounce 500 for the veneer. Dip uptake of individual veneers will vary hence the average uptake should be assessed rather than that of individual veneers on the basis of total dosage throughout. |
| Processing & softwood timber & hardwood plywood for export | Quarantine timber insects | 240mL/m³ dry veneer (gives 120g permethrin per 1m³) | Use in accordance with AQIS Cargo Containers, Quarantine Aspects and Procedures. |

| SITUATION | INSECTS | RATE | CRITICAL COMMENTS |
| :--- | :--- | :--- | :--- |
| Household and industrial situations | Ants, cockroaches, fleas, flies, mosquitoes, spiders, silverfish | 50mL in 10L of light oil or water | All dilutions should be applied to the point of "run-off". That is, at the rate of 5L of prepared spray per 100-150 m² depending on the porosity of the sprayed material. Porous surfaces such as brick, cement, shall be sprayed at heavier dilutions and hence more spray is needed to deliver the required amount of toxic. Apply in cracks, crevices and other insect harbourages. |
| Carpets, rugs and fabrics | Carpet beetle (Anthrenus flavipes) Variegated carpet beetle (Anthrenus verbasci) Webbing clothes moth (Tineola bisselliella) Case-making clothes moths (Tinea pellionella) | 50mL in 10L of water | Apply sufficient spray/ mist to penetrate carpet pile or fabric (50mL spray per m²). Apply as a surface treatment only. For upholstery and fine woollens, do a small, non-conspicuous test area of the carpet. Local stains do imply that to determine that staining and damage will not occur. |
| Lawns, ovals, amenity areas | Lawn armyworm (Spodoptera mauritia) (QLD and NSW only) | 100mL to 200mL/400L water/ha plus 100L/1000L water/600L | Apply at first sign of damage and as and when required. |
| Aircraft | Cockroaches, moths, beetles | Initial: 200mL in 5L of water. Routine: 15mL in 2L of water | Apply to carpets and other fabrics at 25mL spray mix per m² and to other surfaces at 10mL spray mix per m². |
| Repellent treatment of clothing (including clothing) and mosquito nets. (ii) Nylon (iii) Cotton/poly cotton blends | Mosquitoes, biting flies | (ii) 15mL in 500mL water (iii) 15mL in 2L water | The dilution rate depends on the water uptake of the material. Dip thoroughly for 2 minutes, drain then dry, preferably laid flat on a non-absorbent surface. Nets should not be hung up to drain |
| Repellent treatment of clothing of ADF personnel | | 12mL/1L water | Dip treat for 2 minutes, pre-dry on a horizontal rack and finish drying/curing hanging up to dry to prevent excessive dripping. Use in accordance with the Australian Defence Force publication ADFP 705 Pesticides Manual. |

NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION.

GENERAL INSTRUCTIONS
POUNCE 500 is a contact and residual insecticide.
INSECTICIDE RESISTANCE WARNING
GROUP 3A INSECTICIDE

Some naturally-occurring insect biotypes resistant to POUNCE 500 and other Group 3A insecticides may exist through normal genetic variability in any insect population. The resistant individuals can eventually dominate the insect population if POUNCE 500 or other Group 3A insecticides are used repeatedly. The effectiveness of POUNCE 500 on resistant individuals could be significantly reduced. Since occurrence of resistant individuals is difficult to detect prior to use, PCT International Pty Ltd accepts no liability for any losses that may result from the failure of POUNCE 500 to control resistant insects.

POUNCE 500 may be subject to specific resistance management strategies. For further information contact your local supplier, PCT International Pty Ltd representative or local agricultural department agronomist.
Large Scale or Commercial Operations for Dip/Spray treatment of felled logs, poles, posts and sawn timber.
POUNCE 500 can be mixed with water, diesel, light oil or water. Dilution of carrier depends on anticipated exposure to water. Total exposure requires diesel. For timber under shelter, use light oil or water.
Application in diesel will survive up to 3 months exposure in open. Water and light oil applications should be re-applied, to achieve maximum effectiveness of up to 3 months.
Spring frequently and replenish dip as required.
For remedial protection in situ timber may be treated by spraying.
Local Water Authorities should be advised of the proposed use of Pounce 500.
Plywood Manufacture:
Use with water. Production and handling of green veneers will vary site to site, hence a shallow dip bath for treating veneers must be established. Throughput rate and liquid uptake of veneers has to be established. Replacement of appropriately diluted product can be constant or periodic.
Aircraft Disinfection:
Use with water only. Treatment should be carried out in accordance with the relevant Department of Primary Industries and Energy quarantine requirements.
Clothing:
Treated timber must not come into contact with foodstuffs, eg, use in packing cases or places where food is prepared or stored.
DO NOT spray directly on exposed food utensils or food preparation surfaces.
PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND ENVIRONMENT:
Harmful to fish. DO NOT contaminate streams, rivers or waterways with the chemical or used containers.

STORAGE AND DISPOSAL: Storage in the closed, original container, in a cool well-ventilated area. Do not store for prolonged periods in direct sunlight. Triple or preferably rinse container containers before disposal. Add rinsings to spray tank. Do not dispose of undiluted chemicals on site. If recycling, replace cap and return clean containers to recycler or designated collection point. If not recycling, break, crush or puncture and bury empty containers in a local authority tip. If no landfill is available, bury the containers below 500 mm in a disposal pit specifically marked and set up for this purpose clear of waterways, desirable vegetation and tree roots. Empty containers and product should not be burnt.
SAFETY DIRECTIONS: Product is harmful if swallowed. Will irritate the eyes, nose and throat and skin. Avoid contact with eyes and skin. Do not inhale spray mist. When opening the container and preparing spray, wear cotton overalls buttoned to the neck and wrist (or equivalent clothing), elbow-length PVC gloves and face shield or goggles. Wash hands after use. After each day's use, wash gloves, face shield or goggles and contaminated clothing.
FIRST AID: If poisoning occurs, contact a doctor or Poisons Information Centre. Phone 13 1126. If swallowed, do NOT induce vomiting. Give a glass of water.
MSDS: Additional information is listed in the Material Safety Data Sheet available from PCT International Pty Ltd.
EXCLUSION OF LIABILITY:
This product as supplied is of a high grade and is suitable for the purpose for which it is expressly intended and must be used in accordance with the directions. The user must monitor the performance of this product on climate, geographical or biological variables and/or developed resistance may affect the results obtained. No responsibility is accepted for any breach of this product, save for those excludable conditions implied by the Trade Practices Act or any State legislation.